1991 Chevrolet s10

K2 MOTOR IS RECALLING 1,921 AFTERMARKET HEADLAMPS OF VARIOUS MODELS SOLD FOR USE ON THE ABOVE LISTED VEHICLES. THESE HEADLAMPS ARE MISSING THE AMBER SIDE REFLEX REFLECTOR WHICH FAILS TO CONFORM WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT."

Fix: K2 MOTOR WILL NOTIFY OWNERS AND OFFER A FULL REFUND. THE RECALL BEGAN ON DECEMEBER 17, 2008. OWNERS MAY CONTACT K2 MOTOR AT 1-909-839-2992.

CERTAIN CK MOTORSPORTS COMBINATION HEADLIGHTS, CLEAR CORNER, BUMPER, AND SIDE MARKER LIGHTS SOLD AS REPLACEMENT LAMPS FOR USE ON THE PASSENGER VEHICLES LISTED ABOVE. SOME COMBINATION LAMPS THAT ARE NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.

Fix: CK MOTORSPORT WILL NOTIFY OWNERS AND REPLACE THE NONCOMPLIANT LAMPS FREE OF CHARGE. THE RECALL BEGAN ON JULY 1, 2006. OWNERS MAY CONTACT CK MOTORSPORT AT 1-909-610-7211.

CERTAIN PRO-A MOTORS CORNER LAMPS, TURN SIGNALS, AND HEADLIGHTS SOLD AS REPLACEMENT LAMPS FOR USE ON CERTAIN PASSENGER VEHICLES LISTED ABOVE. SOME COMBINATION LAMPS THAT ARE NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.

Fix: PRO-A MOTORS WILL NOTIFY OWNERS AND OFFER TO REPURCHASE THE LAMPS. THE RECALL BEGAN ON APRIL 3, 2006. OWNERS MAY CONTACT PRO-A MOTORS AT 323-838-2988.

VEHICLE DESCRIPTION: CERTAIN 4-WHEEL DRIVE PICKUP TRUCKS AND SPORT UTILITY VEHICLES EQUIPPED WITH ABS (ANTILOCK BRAKING SYSTEM) MANUFACTURED FROM SEPTEMBER 1989 THROUGH AUGUST 1996. UNDER CERTAIN DRIVING CONDITIONS THE SWITCH WHICH SIGNALS THE ABS SYSTEM WHETHER THE VEHICLE IS IN 2-WHEEL OR 4-WHEEL DRIVE CAN MALFUNCTION CAUSING INCREASED STOPPING DISTANCES DURING ABS STOPS WHILE IN THE TWO-WHEEL DRIVE MODE.

Fix: DEALERS WILL REPLACE OR REPAIR THE 4-WHEEL/2-WHEEL DRIVE SWITCH.

VEHICLES HAVE BEEN SHIPPED WITH THE FUEL TANK SENDER SEAL OUT OF POSITION.

Fix: REPLACE SENDER SEALS.

THE INTERMEDIATE STEERING SHAFT LOOSENS AT THE STEERING SHAFT TO STEERING GEAR COUPLING. WITH THIS LOOSENESS, THE YOKE PINCH BOLT CAN WEAR ON THE SPLINES OF THE SHAFT UNTIL THERE IS NO LONGER AN INTERFERENCE BETWEEN THE SPLINES AND THE BOLT.

Fix: DEALERS WILL RETORQUE THE UPPER AND LOWER BOLTS TO CORRECT SPECIFICATIONS.

USE OF IMPROPER PRIMER ON METAL SURFACES OF WINDSHIELD AND SIDE WINDOW OPENINGS COULD CAUSE LOW ADHESION TO THE METAL SURFACE AND WOULD NOT PROVIDE RETENTION REQUIRED BY FMVSS 212.

Fix: REMOVE AND REINSTALL GLASS USING PROPER PRIMER.

THE ENGINE COOLING FAN BLADES BREAK AS A RESULT OF FATIGUE AND/OR VEHICLE INDUCED STRESS.

Fix: INSTALL A NEWLY DESIGNED FAN ASSEMBLY.

NUTS USED TO ATTACH LOWER CONTROL ARMS, REAR SPRING AND SHACKLE, AND REAR SHOCK ABSORBERS DO NOT MEET SPECIFICATIONS AND COULD "STRIP".

Fix: REPLACE LOWER CONTROL ARM ATTACHMENT NUTS AS WELL AS REAR SPRING AND SHACKLE, AND REAR SHOCK ABSORBER NUTS.