2000 Chevrolet s10

CERTAIN AAI MOTORSPORTS COMBINATION LAMPS SOLD AS REPLACEMENT LAMPS FOR USE ON THE ABOVE LIST PASSENGER VEHICLES. COMBINATION LAMPS NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT."

Fix: AAI MOTORSPORTS WILL NOTIFY OWNERS AND REPLACE THE LAMPS FREE OF CHARGE. THE RECALL BEGAN ON AUGUST 1, 2006. OWNERS MAY CONTACT AAI MOTORSPORTS AT 909-923-9188.

SABERSPORT IS RECALLING 16,270 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS.

Fix: SABERSPORT WILL NOTIFY OWNERS AND OFFER A FULL REFUND FOR THE NONCOMPLIANT COMBINATION LAMPS. THE SAFETY RECALL BEGAN ON MAY 11, 2009. OWNERS MAY CONTACT SABERSPORT AT 1-909-598-7589.

DOPE, INC. IS RECALLING 42,540 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS.

Fix: DOPE, INC. WILL NOTIFY OWNERS AND OFFER A FULL REFUND FOR THE NONCOMPLIANT COMBINATION LAMPS. THE SAFETY RECALL BEGAN ON JULY 28, 2009. OWNERS MAY CONTACT DOPE, INC. AT 1-626-272-1798.

CERTAIN AJ MOTORSPORT COMBINATION LAMPS SOLD AS REPLACEMENT LAMPS FOR USE ON THE ABOVE LISTED PASSENGER VEHICLES. COMBINATION LAMPS NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.

Fix: AJ MOTORSPORT WILL NOTIFY OWNERS AND OFFER REIMBURSEMENT FOR THE LAMPS. THE RECALL BEGAN ON JULY 31, 2006. OWNERS MAY CONTACT AJ MOTORSPORT AT 626-618-2026.

VEHICLE DESCRIPTION: LIGHT DUTY PICKUP TRUCKS AND SPORT UTILITY VEHICLES. SOME OF THESE VEHICLES WERE BUILT WITH INCORRECT PAYLOAD INFORMATION ON THE VEHICLE CERTIFICATION LABEL. THE PAYLOAD SHOWN ON THE LABEL IS GREATER THAN THE MAXIMUM VALIDATED PAYLOAD. IF THE VEHICLE WERE LOADED TO THE INCORRECTLY LABELED PAYLOAD, IT MAY NOT RIDE AND HANDLE IN THE MANNER THAT THE DRIVER EXPECTS.

Fix: OWNERS WILL BE SENT A NEW LABEL FOR INSTALLATION ON THE DRIVER'S DOOR OF THE VEHICLE.

VEHICLE DESCRIPTION: S -TRUCKS EQUIPPED WITH 2 WHEEL DRIVE. THESE VEHICLES MAY HAVE HAD THE RIGHT-HAND ANTILOCK BRAKE SYSTEM (ABS) MODULE FEED PIPE AND/OR BRAKE CROSSOVER PIPE TUBE NUTS TIGHTENED WITHOUT SEATING THE PIPE-FLARED-ENDS ENOUGH TO WITHSTAND NORMAL ASSEMBLY AND VEHICLE INPUTS WITHOUT PARTIALLY UNSEATING. THIS DOES NOT COMPLY WITH REQUIREMENTS OF FMVSS NO. 105, "HYDRAULIC SERVICE BRAKE NORMAL, EMERGENCY…

Fix: DEALERS WILL INSPECT THE BRAKE PIPE UNION FOR SIGNS OF BRAKE FLUID, AND IF NECESSARY, INSTALL A NEW BRAKE PIPE UNION.

CERTAIN DELPHI FUEL PRESSURE REGULATORS, P/NOS. FP10020-11B1, FP10026-11B1, AND FP10027-11B1, SOLD AFTER JANUARY 9, 2007, AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES LISTED ABOVE. THE UNIVERSAL PRESSURE REGULATORS (UPR) WERE PRODUCED WITHOUT AN O'RING AND RETAINER.

Fix: DELPHI WILL NOTIFY OWNERS AND REPLACE THE UPR FREE OF CHARGE. THE RECALL BEGAN ON APRIL 23, 2007. OWNERS CAN CONTACT DELPHI AT 877-411-8770.

VEHICLE DESCRIPTION: LIGHT DUTY PICKUP TRUCKS EQUIPPED WITH 4-WHEEL DISC BRAKES. SOME OF THESE VEHICLES HAVE AN ANTILOCK BRAKE SYSTEM (ABS) MOTOR CONTAINING AN OUT-OF-SPECIFICATION SPRING CLIP. THIS CLIP COULD ALLOW THE MOTOR BEARING TO BECOME MISALIGNED. IF MISALIGNMENT OCCURS, EVENTUALLY THE ABS WOULD BE NON-FUNCTIONAL.

Fix: DEALERS WILL REPLACE THE BRAKE PRESSURE MODULE VALVE ASSEMBLY.

VEHICLE DESCRIPTION: PASSENGER VEHICLES, LIGHT DUTY TRUCKS, SPORT UTILITY VEHICLES, AND MINI VANS EQUIPPED WITH TRW SEAT BELT BUCKLE ASSEMBLIES. THE BUCKLE BASE OF THESE SEAT BELT ASSEMBLIES WERE NOT PROPERLY HEAT TREATED AND THEREFORE DO NOT PASS THE LOAD BEARING REQUIREMENT OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 209, "SEAT BELT ASSEMBLIES."

Fix: DEALERS WILL INSPECT THE VEHICLE'S SAFETY BELT BUCKLE ASSEMBLY DATE CODES AND, IF NECESSARY, WILL REPLACE ANY SAFETY BELT BUCKLE ASSEMBLY.