Recall 10V624000 · manufacturer campaign R58

What's wrong

HONDA IS RECALLING MODEL YEAR 2007-2008 HONDA FIT VEHICLES. DUE TO AN ERROR DURING INSTALLATION OF THE WIRING HARNESS FOR THE COMBINATION SWITCH THAT CONTROLS LOW HEAD BEAM FUNCTION, THE WIRES FOR THE LOWER BEAM CIRCUIT WERE PULLED TIGHTER THAN INTENDED. AFTER REPEATED USE OF THE HEADLIGHT SWITCH, THE ELECTRICAL CONNECTOR TERMINAL FOR THE LOW BEAM HEADLIGHT CIRCUIT CAN BECOME WORN AS A RESULT OF THIS TENSION, WHICH CAN RESULT IN LOW CONDUCTIVITY AND CAUSE AN ACCUMULATION OF COPPER OXIDE IN THE AREA OF THE CONTACTS.

The risk

THE LOW BEAM HEADLIGHTS CAN BECOME INOPERATIVE DECREASING THE DRIVER'S VISIBILITY AS WELL AS THE VEHICLE'S VISIBILITY TO OTHER DRIVERS, INCREASING THE RISK OF A CRASH.

The fix

DEALERS WILL INSPECT THE LOW BEAM TERMINAL AND PERFORM NECESSARY REPAIRS FREE OF CHARGE. THE SAFETY RECALL BEGAN ON JANUARY 24, 2011. OWNERS MAY CONTACT HONDA AT 1-800-999-1009.

HONDA'S SAFETY RECALL NO. R58.OWNERS MAY ALSO CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S VEHICLE SAFETY HOTLINE AT 1-888-327-4236 (TTY 1-800-424-9153), OR GO TO <A HREF=HTTP://WWW.SAFERCAR.GOV>HTTP://WWW.SAFERCAR.GOV</A> .

Vehicles covered by this recall

Whether a particular car is affected and still unrepaired depends on its VIN — a model year being listed does not mean every car of that year is included. Check any VIN free on CarLogs, or at nhtsa.gov/recalls.

Is this car's recall fixed?

Recall repairs are free at any franchised dealer, for the life of the vehicle. A CarLogs report shows the recall status for a specific VIN as reported by the manufacturer — whether it's open or repaired, and whether the fix is available yet.

Source: NHTSA Office of Defects Investigation recall database. Look up another campaign →