Recall 20V023000
Power Train › Axle Assembly › Axle Shaft — Terex Advance · reported 17 Jan 2020 · 34 vehicles potentially affected
What's wrong
Terex Advance Mixer (Terex) is recalling certain 2020 FDC300, FD4000, FD5000GL, and FD7000B vehicles. The axle output shafts were incorrectly heat treated, possibly causing them to fracture.
The risk
The fracturing of the output shaft would result in a loss of drive, increasing the risk of a crash.
The fix
Terex has notified owners. Owners should inspect the Dana output flange for its production date. Dana will replace any that are in the affected range, free of charge. The recall began January 24, 2020. Owners may contact Terex customer service at 1-800-678-5961.
Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.NHTSA is missing critical, required information for this safety recall. This information must be supplied through the NHTSA Recalls Portal within 5 working days of confirming its accuracy:- A statement that the defect or noncompliance can cause a vehicle crash without prior warning; or a description of whatever prior warning may occur, and a statement that if this warning is not heeded, a vehicle crash can occur (49 CFR 577.5 (f)(1)).
Vehicles covered by this recall
Whether a particular car is affected and still unrepaired depends on its VIN — a model year being listed does not mean every car of that year is included. Check any VIN free on CarLogs, or at nhtsa.gov/recalls.
Is this car's recall fixed?
Recall repairs are free at any franchised dealer, for the life of the vehicle. A CarLogs report shows the recall status for a specific VIN as reported by the manufacturer — whether it's open or repaired, and whether the fix is available yet.
Source: NHTSA Office of Defects Investigation recall database. Look up another campaign →