Recall 91V204000

What's wrong

THE BOLTS AND NUTS WHICH ATTACH THE BEARING-HUB ASSEMBLY TO THE REAR AXLE FLANGE ARE NOT SUFFICIENTLY TIGHTENED ON SOME VEHICLES.

The risk

THIS WOULD ALLOW EXCESSIVE MOVEMENT OF THE BEARING-HUBASSEMBLY RELATIVE TO THE REAR AXLE FLANGE AND COULD CAUSE ELONGATION ANDEVENTUAL SEPARATION OF THE ATTACHING BOLTS FROM THE REAR AXLE FLANGE. IF THISWERE TO OCCUR WHILE THE VEHICLE WAS IN MOTION, THE AFFECTED TIRE AND WHEEL COULDTRACK ERRATICALLY, EVENTUALLY CAUSING FAILURE OF THE OTHER ATTACHING BOLTS. THETIRE AND WHEEL ASSEMBLY COULD SEPARATE FROM THE VEHICLE WHICH COULD RESULT IN AVEHICLE ACCIDENT.

The fix

TIGHTEN REAR AXLE BEARING-HUB ASSEMBLY FASTENERS, AND REPLACE ALL THE FASTENERS ON A WHEEL IF TWO OR MORE BOLTS ARE FOUND TO BE LOOSE.

SYSTEM: REAR AXLE.VEHICLE DESCRIPTION: PASSENGER CARS.NOTE: GENERAL MOTORS REPORTS THAT ALL SUBJECT VEHICLES WERE HELD AND REPAIREDBEFORE ANY OWNER TOOK POSSESSION, SO THERE WILL BE NO OWNER NOTIFICATION.

Vehicles covered by this recall

Whether a particular car is affected and still unrepaired depends on its VIN — a model year being listed does not mean every car of that year is included. Check any VIN free on CarLogs, or at nhtsa.gov/recalls.

Is this car's recall fixed?

Recall repairs are free at any franchised dealer, for the life of the vehicle. A CarLogs report shows the recall status for a specific VIN as reported by the manufacturer — whether it's open or repaired, and whether the fix is available yet.

Source: NHTSA Office of Defects Investigation recall database. Look up another campaign →